Introduction
Use this guide to replace the webcam, aka "webcam module," in your Framework 16" laptop.
-
-
While supporting the screen with one hand, use your Framework Screwdriver to remove the two 2.0 mm‑long T5 Torx screws securing the webcam.
-
-
-
Use the magnetic tip of your Framework Screwdriver to pull the two washers off the Top Cover.
-
-
-
Use the flat end of a spudger, or a clean fingernail, to lift up the locking tab on the webcam ZIF connector.
-
-
-
Grip the edges of the webcam and lift it straight up so its cable slides out of the ZIF connector.
-
Remove the webcam.
-
To reassemble your device, follow these instructions in reverse order.
Take your e-waste to an R2 or e-Stewards certified recycler.
Repair didn’t go as planned? Try some basic troubleshooting, or ask our Answers Community for help.
