Introduction

If your LG Vortex is taking blurry photos, failing to focus, or the rear-facing camera app won’t even open, it’s likely that the camera module itself needs replacing. This guide will walk you through the steps to safely remove and replace the rear-facing camera on your LG Vortex. You’ll need a few small tools such as a precision screwdriver (typically a Phillips #00), a plastic spudger or opening tool, and a clean, static-free workspace. The internal components of the LG Vortex are compact and delicate, so take extra care when handling ribbon cables or connectors to avoid tearing or damaging them. Also, be sure to keep track of all screws and small parts, as losing even one can make reassembly difficult. This repair requires partial disassembly of the phone, so it’s a good idea to familiarize yourself with the back cover and internal layout beforehand. Replacing the rear-facing camera isn’t overly complicated, but it does require patience and a steady hand. By following this guide, you'll be able to remove the malfunctioning camera module and install a new one, restoring the full photo-taking capabilities of your device.

  1. Mhye11DPvMdgvtbo
    • Power the phone off

    • The power button is located on top of the phone

  2. PcfwyBykuFZUA66k
    PcfwyBykuFZUA66k
    gbCMNDcE1dv445FZ
    RRL2WHkOKWDUxPko
    • Find the two thumbnail ridges on the side and top of the phone. One is next to the micro SD slot and the other at the top of the phone

    • Once the ridges are located, use the blue plastic opening tool to pry the back cover away from the rest of the phone.

    • Remove the back cover and set it to the side.

  3. ugNQHTaIEtZAHJPQ
    • Remove the battery using the blue plastic opening tool.

    • There is a small thumbnail ridge at the top left corner of the battery for ease of removal.

    • Put the battery aside.

  4. smmXheHhVk1RtRhf
    smmXheHhVk1RtRhf
    nre3VslUKB4dA62G
    • All screws are the same size screwdriver head #00

    • Use the precision screwdriver to remove the 6 screws along the edges of the phone.

    • There are 2 screws at the top in each corner, 2 in the middle on the sides, and 2 in the bottom corners.

    • Place the screws in a container to ensure they aren't lost.

    Can you tell me who I or how to get the part that I need?

    Roger Evans -

    Hey it's the guy who has the V22 Vortex.That needs the chargring housing. I asked if anyone could possibly steer me in the right direction,as to where and how to get the part.But I know Just thought you AhFuck you.

    Roger Evans -

  5. ALkWa4ERHMVS1Xle
    ALkWa4ERHMVS1Xle
    cpgZpOJvPH2bJAiS
    BMqZHVC1UCAu131u
    • Use the blue plastic opening tool to remove the back frame from the rest of the phone.

    • Pry at the micro SD slot. Push the cover for the SD slot away from the front of the phone and pry the back frame away from the rest of the phone.

    • Pry your way around the entire phone to separate the face from the frame.

    ModelV22 Vortex. I need the charging port hole assembly.

    Roger Evans -

    Ok I have aV22 Vortex.Or should I say.I need the charging plug in assembly.C charger port.I'm sure I didn't say that right.But if needed I will send a picture of it.

    Roger Evans -

  6. XIA1yvklasdQFdpk
    XIA1yvklasdQFdpk
    UNDZaSI1TCFUgbNK
    k1RdeohdpYqs5BBL
    • NOTE: This is the most difficult step.

    • Identify the system board (the main circuit board) inside, and locate the camera module area at the top.

    • You’ll see a black plastic component around the camera that’s seated on (but is not soldered to) the system board.

    • On each side of that black plastic piece, there are 2 black tabs securing it to the board. Gently pry these tabs outward (away from the board).

    • Hold them off the board, because they may snap back if released.

    • This is one of the trickiest areas — proceed slowly.

  7. uvA3cGr3BWJX1AQ2
    • Using the blue plastic prying tool remove the black piece next to the camera.

    • Do not damage the thin wires attaching the motherboard to the speakers

  8. Hv5AWbqCmAMyQrsQ
    • Remove with caution.

    • Disconnect the cord attaching the camera to the system board.

    • Once the tabs are held back, use a prying tool to lift the black housing—the piece that holds the camera—away from the system board.

    • Work gradually along its edges, making sure not to tug on wiring nearby.

  9. duYAv5fNucCysgJf
    duYAv5fNucCysgJf
    cY5wdtelISVlKskT
    J3iNOLCg1sIBkGns
    • The camera module is secured by a small sticker or adhesive tab on its top.

    • Carefully pry this piece away with your fingernail, watching out for thin wires (e.g. wires connecting the board to speakers or other parts).

    • Once the adhesive is loosened, gently lift the camera straight up and off the board.

    • Pull the camera off the system board using your fingers. Perform this step with caution.

  10. bY3SXxFGA2DHMvu2
    • Place the new camera module in the exact orientation and location where the old one sat.

    • Reapply the sticker/adhesive back over the top of the camera (or use new adhesive if supplied).

    • Ensure the camera sits flush and aligned correctly.

  11. qYkXXBqkIy4bNjdG
    • Reverse the steps above to reassemble the phone.

Conclusion

To reassemble your device, follow these instructions in reverse order.

Jen

Member since: 13/02/14

40 Reputation

4 comments

First, clean the cookware with water and a mild kitchen soap to remove anything that might be on the surface. Rinse with hot water. I do uk.bestessays.com and Then coat the entire bottom of the pan in vegetable oil in this case, canola oil and turn it over onto a paper towel for 10 minutes.

William Peter -

Offer massages in my sanctuary or in the comfort of your own home

<a href="https://thecarriagehousesanctuary.square...">Top Massage Therapist in Westchester County NY</a>

Junaid Khan Akazai -

Offer massages in my sanctuary or in the comfort of your own home

Top Massage Therapist in Westchester County NY

Junaid Khan Akazai -

Offer massages in my sanctuary or in the comfort of your own home <a href="https://thecarriagehousesanctuary.square...">Best Massage Therapist in Westchester County NY</a>

Junaid Khan Akazai -